Introduction
Most people don't think about how to disassemble their vacuum cleaner, but if you're the type who likes to know how things work, or if you need to repair your vacuum, you'll need to know how to take it apart. This article will show you how to disassemble an electrolux vacuum cleaner so that you can either fix it or see how it works!
Step by Step guide on How to Disassemble an Electrolux Vacuum Cleaner?
1. Unplug the Handheld vacuum cleaner from the power outlet.
2. Remove the dustbin by pressing the release button and lifting it out.
3. Twist off the floor nozzle by hand or use a Phillips head screwdriver to remove any screws holding it in place.
4. Lift up the roller brush assembly and pull it out towards you.
5. Unscrew the four screws holding the motor housing in place using a Phillips head screwdriver.
6. Pull out the old motor and replace it with a new one.
7. Reassemble the vacuum cleaner in the reverse order of disassembly.
Tools and Materials Needed
You will need a few tools to disassemble your Electrolux vacuum cleaner, including a Phillips head screwdriver, a flat head screwdriver, and a small pair of pliers. You will also need a new dust bag and filter.
Start by unplugging the vacuum cleaner and removing the hose. Use the Phillips head screwdriver to remove the screws from the bottom plate. Lift off the bottom plate and set it aside.
Remove the motor cover by loosening the screws with the Phillips head screwdriver. Lift off the cover and set it aside. Disconnect the wires from the motor (be sure to note which wire goes where).
Remove the screws that hold the motor in place and lift it out of the vacuum cleaner. Set it aside.
Now you will be able to access the dust bag. Remove it from the vacuum cleaner and discard it. Insert the new dust bag into place.
Replace the motor (making sure to reconnect the wires correctly) and reattach the motor cover. Screw the bottom plate back on and reattach the hose. Your Electrolux vacuum cleaner is now ready to use!
image source: https://www.pinterest.ph
Why You Would Need to Disassemble Your Vacuum Cleaner?
If you're like most people, you probably don't think much about your vacuum cleaner until it stops working. But if you take a little time to learn how to disassemble your vacuum cleaner, you'll be able to fix many common problems yourself.
There are several reasons you might need to disassemble your Wet&Dry vacuum cleaner. For example, if the roller brush isn't spinning, it could be because the belt has come off. To fix this, you'll need to remove the bottom plate of the vacuum so you can access the brush.
If your vacuum isn't picking up dirt as well as it used to, it might be because the dustbin is full. To empty it, you'll need to take off the top of the vacuum so you can access the bin.
And if your vacuum just isn't working at all, you may need to replace the power cord. To do this, you'll need to remove the screws that hold the cord wrap in place so you can access the cord.
Learning how to disassemble your vacuum cleaner is relatively easy and only takes a few minutes. But it's a valuable skill that can save you time and money in the long run.
image source: https://www.pinterest.ph
Conclusion
We hope this Vacuum cleaner Supplier guide on how to disassemble an Electrolux vacuum cleaner has been helpful. Remember to always consult the manual for your particular model before attempting any repairs. With a little patience and some basic tools, you should be able to easily take apart your vacuum cleaner and get it back to working order in no time.